Banner

5 résultats trouvés

Profili and Jedicut interface - File Preparation

I'm very new to Jedicut. I've built my HobbyCNC board and run some of the Jedicut files on it with the steppers all just sitting on my bench. I put tape on the shafts to watch them rotate easier. What I currently have in addition to Rhino is Profili Pro 2.8 or whatever. AND possibly I should be aski...

Re: Next version of JediCut?

What I would LOVE TO SEE in an upcoming version is ... A direct import of Stephano Duranti's Profili output ! Yes I can bring over .dat files for tip and root. But there is the G-code output that does everything. His 3D Sim of cutting action is terrific. His program is low cost. Jedicut is fairly Ma...

Re: Set ups for HobbyCNC board

Thanks for quick reply ! I have NO external timer. What frequency should it be IF I make one ? Could it be a simple 555 timer circuit ? YES , that MaxCom.dll does work to a slight degree. I just cannot get the Speeds to change no matter the setting. I am using .009 mm / step My board is set to 1/ st...

Set ups for HobbyCNC board

I am using an old win98 Laptop by Toshiba. It uses LPT2 not LPT1 and that is on 378 I am amazed that Jedicut figured that out I have found NOT setting to actually select that address. I have built and tested my HobbyCNC board on all 4 axies. I used a Parallel port monitor program to single step for ...

Aller à la recherche avancée

`); }); })(jQuery, window, document, phpbb);