Ad blocker detected : Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Aller à la recherche avancée
Bonsoir,
J'ai Jedicut 2.3.2 build 2, ça semble OK
dxf_import_jedicut.JPG
Vu 5417 fois 20.61 Kio
Bonsoir,
Chez moi ton fichier dxf semble correctement importé dans Jedicut...
Quelle version de Jedicut utilises-tu ?
Hi,
IO.sys doesn't work with win 7.
It must be delete from the jedicut's folder if win 7 is used, like others old plug-in witch use this file.
You should uninstall and delete all jedicut dll files, and install lastest version with the installer, not with the zip with copy old files.
- Forum : Jedicut - English board
- Sujet : Windows 7 64 bit error
- Réponses : 4
- Vues : 14582
- sam. mars 16, 2013 9:30 pm
- Aller au message
[quote=thierry] merci de toutes ces précisions je ne vois pas pourquoi il faut une alim stabilisé elle pilote quoi exactement la carte en combien de volt doit elle sortir et ce pont de diode je ne vois pas non plus ou le positionner merci encore[/quote] C'est simple sur une machine de découpe CNC il...
Bonjour thierry, Ta liste est correcte il manque juste pour le fil chaud un pont de diode redresseur et un filtre à base de condensateur pour en faire une alimentation un minimum stabilisé, pour que ton fil chaud ait un meilleur rayonnement. Les plan et explications pour se faire une alimentation st...
Hi, There are 2 functions for the heat : ON/OFF and the dynamic heat. For the On/Off function don't think the synchronization is needed. But for the dynamic heat, I think that the heat value is calculated with many parameters, wich need a fixe reference timer to adjust heat when the cutting wire do ...
- Forum : Jedicut - English board
- Sujet : Jedicut and Arduino over USB
- Réponses : 224
- Vues : 217744
- sam. déc. 15, 2012 9:49 am
- Aller au message
Hi, Martin, the fixed Jedicut's configuration is OK. But I've found the issue...the pins assignment of my mm2001 doesn't match with the configuration you indicated, and with the schema...I don't know why... So I've tested each pin out with LED, to be sure, and re wire and now the manual motors contr...
- Forum : Jedicut - English board
- Sujet : Jedicut and Arduino over USB
- Réponses : 224
- Vues : 217744
- mer. déc. 12, 2012 4:32 pm
- Aller au message
Hello, Total fail :( The Jedicut's progress bar when cutting is very fast, too fast. I respected the fixed Jedicut configuration, and wire Arduino's outs to the matches pins of my mm2001. But with the last firmware, nothing move... The on/off motor function doesn't work, too... I'va added a delay in...
- Forum : Jedicut - English board
- Sujet : Jedicut and Arduino over USB
- Réponses : 224
- Vues : 217744
- sam. déc. 08, 2012 6:08 pm
- Aller au message
Aller à la recherche avancée