Turns out that all was caused by my chinese arduino nano. Sorry to put a fake problem. Jedicut is working very wel.
Regards to all
Ad blocker detected : Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
32 résultats trouvés
I will try to refine the problem: I´m using a pw51.dat or pw1211.dat or ag03.dat profiles. All gave the same result. The machine starts to cut and suddenly the progress bar freezes, and I can not do nything else. I have to shutdown Jedicut and reinialize it to get control of the motors again. The fr...
Hello all, I´m using Jedicut for a while and everything was working fine, Suddenly it started to stop working in random parts of the cut, I´m using win 7 with an arduino uno board, The problem started when I tryed to cut a wisel wing using PW51 profile. Jedicut was the last software installed. The o...
Hello all. I just solved the problem. I just inclined the x1-x2 plane. Since the foam was parallel to the table I could manage to cut the left wing tip obliquous to the right tip. My english is not very good but if you look at the project you are going to understand what I´m saying. Regards to all A...
Hi Alan, merci for you fast answer, but I think I could not make my self clear. I´ll use you picture to try to be more precise: Using your cuting wizard picture the décalage in my machine is 102,5 mm, That is just becouse the way my machine was built. The leading edge of any wing in my machine is no...
Hello all, greetings from Brasil! I´m using Jedicut for some time and after solve all mechanical and electronics problems, I finally managed to cut several pairs of wings in very preciselly and clean cuts. Now, I´d like to cut a wing for a Alula based project. In this project the wing tip is 30 mm a...
Hello Javier and Jerôme, everything is working. I have just to calibrate the speed to cut, but this is a small problem. Thanks again for the help.
Alfredo from Brasil
Alfredo from Brasil
Hi Javier and Jerôme, Thanks for your help. I found that the problem was with the settings of com port on [b]windows device manager[/b]. After adjusting the settings to 115200, no parity, 8 data bits and 1 stop bit everything start to works right. Now I´m trying to figure out how to control the hot ...
Hello all! I´m Alfredo from Brasil. I just finished a arduino uno board with a CNC shield v3. I´ve followed all instructions given by TJMarch on post 207. The motors were tested and all four are working outside jedicut. I did the jedicut configuration using the same parameters as TJmarch on the same...
- La découpe CNC au fil chaud - Forums Français
- - Jedicut - Logiciel CNC de découpe au fil chaud
- - Cartes de contrôles CNC & Electronique
- - Machines CNC & Mécanique
- - Fichiers de découpe CNC - Profils, formes, avions...
- - Plugins pour Jedicut
- Hot wire foam cutter - English board
- - Jedicut - English board
- - Les sites des aéromodélistes
- - Petites annonces entre modélistes
- - Aero 2009
- - AeroMicro