Ad blocker detected : Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Aller à la recherche avancée
[quote=MAES] When you move manual the axis x or y with a value 250mm , the axis must drive 250mm. You can test it and maesure the distance. Is the distance not correct, you must change in Jedicut the value for "nb mm/pas". You can make a simple projekt with one rectangle as airfoil and sym...
- Forum : Jedicut - English board
- Sujet : CUT Problem
- Réponses : 6
- Vues : 7188
- sam. mai 31, 2014 8:31 am
- Aller au message
Good morning I have a problem With my CNC I cut the figure in Annex A. I imported the profile in jedicut (see Annex B) On jedicut I see the right profile (see attachments C) When cutting the foam, the geometry does not match with the program. (See clouds on Annex A) I state that the axes of the CNC ...
- Forum : Jedicut - English board
- Sujet : CUT Problem
- Réponses : 6
- Vues : 7188
- ven. mai 30, 2014 12:37 pm
- Aller au message
[quote=MAES]
When the timer-impuls is correct and you have in Jedicut select "with external timer",
you must change the cut-speed to a short value (20...).
Manfred[/quote]
if I had a speed value of 80'000'000
with a timer of 2000HZ
what is the new speed value?
Thanks
- Forum : Jedicut - English board
- Sujet : MM2001 jedicut heating control
- Réponses : 7
- Vues : 7218
- mer. mai 28, 2014 1:26 pm
- Aller au message
[quote=MAES]
Without external-timer you can not use the heating-control in Jedicut.
You must show, that the timer-impuls from the MM2001 is correct.[/quote]
I don't have an oscilloscope but the timer-impuls is correct because i used GMFC
- Forum : Jedicut - English board
- Sujet : MM2001 jedicut heating control
- Réponses : 7
- Vues : 7218
- dim. mai 25, 2014 11:19 pm
- Aller au message
Good morning
I'm trying jedicut
My configurations are attached to the message
The CNC works, there is only a problem, I can't use heating control.
When I enable the "synchronize engine rotation with external timer" the CNC stops to go.
Could you give me some advice?
Thanks
- Forum : Jedicut - English board
- Sujet : MM2001 jedicut heating control
- Réponses : 7
- Vues : 7218
- dim. mai 25, 2014 3:18 pm
- Aller au message
Aller à la recherche avancée