Yes, I figured that out.I did not know that I had to load file file for both(at least the first time anyway).
ANy e.t.a on the next update????:)

IT WORKED!!! yea. Thank you Jerome!!! I kept tring to say -600mm ,Jedicut did not like it very much, now I understand. Still had an issue but was able to work around it.. I tried check symetrical, without loading the file in the WING tip area, which resulted in a "can't calculate points" e...

Thank you for the help..will give it a go tomorrow(it's 11:33 pm now)
Will post results, good or bad.
It's still daylight out.........

Actually its horizontal 600 mm, up 6.5mm, back 600, up 6.5....and so on
this it to cut 6 mm "sheets" of foam.

Thank you!

somebody???

Play ing around, trying to get simple planks to cut...Cut preview/cut ..I get an error message that it can't calculate points, somebody please help!