Banner

33 résultats trouvés

Re: CPX file type

[quote=Jerome] Jedicut should open profiles corresponding to "Emplature" and "Saumon" part, nothing else ? Is it right ? It's more easy to do that than convert CPX to JDC. :S[/quote] I did not want to admit that I do not understand what it means "Emplature" and "Sa...

Re: Cut speed

[quote=Jerome]
Do you try to move foam to the extrem left of the table, near motors (or to the extrem right) ?[/quote]

Yes, this is the best thing I can do. But it is bit too little.

Re: CPX file type

[quote=Jerome] It's more easy to do that than convert CPX to JDC. :S[/quote] Life is not easy.:)-D I have problem with profiles where tip and root are diferent or have different chords. Cutting wizzard does strange cutting lines sometimes. In Complexes I can set start point and equal number of point...

Re: Cut speed

Hi Jerome My question was half-baked. I want to make sure, your algorithm uses max cut speed on the side where is more steps to do. Eg. Jedicut sends sequentialy 10 steps on X1 side and 1 step on X2 side - max speed on X1 side and 10% on X2 side. In addition I have a little problem with Cut wizzard....

Re: CPX file type

[quote=Jerome]
The main difficulty is to find time to do it...[/quote]

I uderstand you.

[quote=Jerome]
Are you also interested by this plugin ?[/quote]

Yes, I have problem with more complex shapes.

Cut speed

Hi Jerome
I set cut speed but I don't know for what point of wire it is calculated: X1, Root, Tip, X2 or another.
It is important when root and tip chord are significantly different.
Can you explain the problem?

Aller à la recherche avancée

`); }); })(jQuery, window, document, phpbb);