Banner

2596 résultats trouvés

Re: comment recevoir le programmme JEDICUT , quel prix...

Bonjour, J'ai déplacé votre message afin de créer une nouvelle discussion et pouvoir apporter une réponse simple : - Jedicut est téléchargeable gratuitement sur cette page , - Jedicut est présenté sur cette page , - Jedicut contient également une aide accessible sur votre ordinateur après l'installa...

NiChrome Wire

Hello Everyone, What has everyone found to be the best wire size (diameter) for foam cutting. I have been using 1mm, but I notice that smaller diameters are available. My guess is that the smaller the diameter the better, but there will be a point at which it is not practical or flex? Regards, Luke

Re: cutting speed

Hi, If you check "Smooth" option in manual control panel, Jedicut will control your engine like this (for horizontal movement) : X1, X2, X1, X2, X1, X2... If you unchek "Smooth" option, Jedicut will control stepper like this (in the same sample) : (X1+X2), (X1+X2), (X1+X2)... In ...

Re: time out

Bonjour, Je ne comprends pas bien la description du problème "Time out". Ce que je sais, c'est que ce message apparait lorsque Jedicut ne détecte pas le signal du timer. Il faut donc que la carte soit alimentée (et que donc le timer externe soit en foncitonnement) avant la commande de tout...

Re: cutting speed

Hi Ulrich, I understand what your are trying to say. I was in the same position, I went through a large amount of foam trying to work out optimum cutting speeds. All looked good until the Intrado/Extrado part of the cut, the speed was about half the speed specified in the cutting options. You are co...

Aller à la recherche avancée

`); }); })(jQuery, window, document, phpbb);