Ad blocker detected : Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Aller à la recherche avancée
Marcos,
nice work (tu)
Manfred
Hallo,
i think, the contour is not complet close, or a minimal line is out the contour.
Manfred
"Cut speed: 4 Fast: 1"
I think, the speed is to high, the stepper lost steps.
You can test it with larger parameter "Cut speed: 30 Fast: 20"
Manfred
Nigel, here my code for a dsPic4013(Microchip). #bit Ser_IN_X1_S = Val.7 #bit Ser_IN_X1_R = Val.6 #bit Ser_IN_Y1_S = Val.5 #bit Ser_IN_Y1_R = Val.4 #bit Ser_IN_X2_S = Val.3 #bit Ser_IN_X2_R = Val.2 #bit Ser_IN_Y2_S = Val.1 #bit Ser_IN_Y2_R = Val.0 #bit Ser_ME_ovf = Ser_Merker.0 #bit Ser_ME_inProg = ...
- Forum : Jedicut - English board
- Sujet : Jedicut and Arduino over USB
- Réponses : 224
- Vues : 218728
- ven. avr. 12, 2013 4:31 pm
- Aller au message
Nigel,
i use my code with TB6560 controllers.
It works.
You must show, that in arduno-code only the Step-pin every time go to low.
void sendMotorCmd(byte cmd)
{
PORTB = (PORTB & 0xF0) | (cmd & 0x0f);
PORTD = (PORTD & 0x0F) | (cmd & 0xf0);
}
Here you must change the Code.
- Forum : Jedicut - English board
- Sujet : Jedicut and Arduino over USB
- Réponses : 224
- Vues : 218728
- jeu. avr. 11, 2013 7:54 pm
- Aller au message
Hi Nigel, i think, the problem is here: /**********************************************************************************/ void handleCommand() { byte val = cmdArray[arrayIdxRead+1]; // The command parameter value switch(cmdArray[arrayIdxRead]) { case 'A': // All Motors on/off if(val == '1') {digi...
- Forum : Jedicut - English board
- Sujet : Jedicut and Arduino over USB
- Réponses : 224
- Vues : 218728
- lun. avr. 08, 2013 5:22 pm
- Aller au message
Aller à la recherche avancée