Page 1 sur 1
carte contrôleur commune
Posté : jeu. sept. 29, 2011 1:34 am
par rui
I made this control board,
http://kitsrus.com/pdf/k179.pdf,
but does not work with Jedicut,
how do i connect it?
thanks
Re: carte contrôleur commune
Posté : jeu. sept. 29, 2011 12:24 pm
par Vincent
Hello Rui,
You must connect the "step" and "dir" pins of your interface with a parallel port, and configure Jedicut to obtain the correct assignation of the pins "step" and "dir".
For example, connect the "step" on the pin 2 of the parallel port, and "dir" on the 3rd pin.
Launch Jedicut, go to "tools", "options", "communication", and select correct pins assignment : 2 for the step, and 3 for the direction.
Your motor should turn if you send an order in manual control.
Re: carte contrôleur commune
Posté : jeu. sept. 29, 2011 11:50 pm
par rui
Thanks for your help.
I've done all this but the engine just tremble, do not rotate.
With the software CENECE the engines spin well,
I have tried all settings available in the JEDICUT, dll's, and nothing works.
Can you help more?
Re: carte contrôleur commune
Posté : ven. sept. 30, 2011 8:22 pm
par Vincent
hello,
ok, so you may try to increase the cut speed and fast speed values in "options", tools", CNC controller.
for example, try this :
nb mm.pas : 0,020780
cut speed : 30000000
fast speed : 15000000
(modify for all axis of course)