Bonjour Vz,
Il est possible de découper des tronçons complets de fuselage.
Dans l'exemple, il faut dessiner un carré ; sur le coté de gauche, ce côté doit être constitué de 2 segments de longueur égale pour avoir un point d'accroche au milieu du coté. Les 2 profils sont chargées, mettre les cordes (150 et 75 mm et les épaisseurs de peau, 0.7 et 1.1( 1.1 car la vitesse du fil chaud va être 1/2 de la vitesse emplanture).
Mettre la hauteur de départ égale à : 150mm / 2 soit 75mm + 5mm de marge sur le brut. donc 80mm. La hauteur de dégagement n'a pas d'importance on ne l'utilisera pas.
Hello Vz,
It is possible to cut out complete sections of fuselage.
In the example, you have to draw a square; on the left side, this side must consist of 2 segments of equal length to have a point of attachment in the middle of the side. The 2 profiles are loaded, put the ropes (150 and 75 mm and the skin thicknesses, 0.7 and 1.1 (1.1 because the speed of the hot wire will be 1/2 of the root speed).
Set the starting height equal to: 150mm / 2 or 75mm + 5mm margin on the stock. so 80mm. Clearance height does not matter, it will not be used.
On passe à l'assistant de découpe: on renseigne la longueur du tronçon, on met la flèche egale à (150 -75) / 2 = 37.5mm, on centre sur la largeur de la table. Nous voyons que l'on a intérêt à avoir une table de découpe modulable en largeur si l'on veut réaliser des tronçon de faible longueur.
We go to the cutting assistant: we inform the length of the section, we put the arrow equals (150 -75) / 2 = 37.5mm, we center on the width of the table. We see that it is advantageous to have a modular cutting table in width if we want to achieve short length sections.
Le cycle de découpe: nous allons faire la découpe en continu sans retour. Vous déplacez le point 1 sur le milieu du coté de gauche et le point 2 dans le coin bas de droite, la première verticale vous cochez "Hauteur de départ", et comptabilisé, ensuite horizontale puis extrados , puis intrados et cocher inversé, horizontale coché RAZ compteur, puis verticale Raz Compteur. Votre fil revient au point de départ.
The cutting cycle: we will cut continuously without return. You move the point 1 on the middle of the left side and the point 2 in the bottom right corner, the first vertical you check "Height of departure", and counted, then horizontal then extrados, then intrados and check inverted, horizontal ticked Reset counter, then vertical Raz Counter. Your thread returns to the starting point.
Simulation découpe: on voit que les 2 couples sont centrés.
Cutting simulation: we see that the two pairs are centered.
Bonne découpe Good cutting
A+
Alain