jedicut.com

Hello,
is it possible to connect jedicut with the stepper board STEP3N and STEP1N from Burkhard Lewetz ?
has anybody experience with this combination ?
Regards
Hans-Peter

Hi,

I have never heared about this board. Do you have documentation or web site ?

Hello,
look at www.lewetz.de
under "Produkte" STEP3N/STEP1N you will find more information.

Where can I buy a complete M2001 board ? that can work with 4x motor 2,5 A
Greets

Hi,

I'm sorry but without french or english documentation i can't do anything : I don't speak deutsch.

You can look at www.axemotion.com to buy a board like MM2001. It's a french website but contact me on this board if you need explaination.

Hello Jerome,
and I can ´t speak/read french . I tried to translate the website with google, but there are some questions:
- I would like to buy a professional built, "redy to run " or "plug and play" MM2001 board with all electric installations like power supply, all connectors, a complete housing, ..... because I don´t understand anything from electronic, solder,... ;-((

- my actual foam cutter has installed 4x stepper motor 200step/revolution and 1.82 A, DC 2.46 V (Step-Syn Sanyo Denki)

- where can I buy this ?

Regards
Hans-Peter
www.lipo-fly.de

Hi,

I think that you can't find a ready to use board. But on www.axemotion.com you can buy a finished board, and you'll just have to add motor and power supply. Another way is to buy a complete installation in a club but it's less interesting :/

Can I help you to understand the website ?

Hello Jerome,
thanks , but I stopped looking for a complete board.

Hans-Peter