Page 1 sur 1

Parallel Port Function

Posté : lun. mai 28, 2007 11:26 am
par Jerome
we would use jedicut with Hobbycnc.
After Install the jedicut software we would test the II Port.
Can we use parmon.exe to test II port.

Can we use a standard II Port cable.

Witch BIOS II option is used for jedicut.

PC with Win 98.

Gruß Sucramsni

Re: Parallel Port Function

Posté : mar. mai 29, 2007 11:05 am
par Jerome
Hello,

You can test parallel port with parmon but only in order to test a signal like "Engine On/Off". Configure Jedicut like I do for MM2001 board.

I'm sorry but I don't know what kind of cable you have tu use. Contact HobbyCNC ;)