CNC Step + own Timer

#1
Hi,

I have a 3D Step controller, a friend got a GWR Controller.
Both dont got a timer on board and offer the timer signal on pin 10.

At http://gm.cnc.free.fr/CNC/timer_quartz.zip I found a small circuit, to build a small timer.

Question: if I built this timer and attach the signal on PIN 10, would this work with Jedicut?

Right now we got with the GWR device major problems. Jedicut is more or less not useable.

An thoughts, comments, ideas?

Jens ( http://www.tron-cnc.de )

Qui est en ligne

Utilisateurs parcourant ce forum : Yahoo [Bot] et 1 invité

cron