Page 1 sur 1

CNC Step + own Timer

Posté : jeu. avr. 17, 2008 8:52 pm
par Jens
Hi,

I have a 3D Step controller, a friend got a GWR Controller.
Both dont got a timer on board and offer the timer signal on pin 10.

At http://gm.cnc.free.fr/CNC/timer_quartz.zip I found a small circuit, to build a small timer.

Question: if I built this timer and attach the signal on PIN 10, would this work with Jedicut?

Right now we got with the GWR device major problems. Jedicut is more or less not useable.

An thoughts, comments, ideas?

Jens ( http://www.tron-cnc.de )

Re: CNC Step + own Timer

Posté : jeu. avr. 17, 2008 10:55 pm
par Jerome
Hello,

Jedicut works with or without external timer. But your cnc board need to be compatible with the kind of signals Jedicut send.