Page 1 sur 1
Heat parallel control
Posté : dim. juin 15, 2008 11:20 am
par urology
Is there a way to set the parallel pin for heat control in CncNet_XP.dll. I use a PCB of HobbyCNC.
http://www.hobbycnc.com/products/auto-h ... board-kit/
Thanks
Re: Heat parallel control
Posté : dim. juin 15, 2008 2:20 pm
par urology
UP.....
This is a question not a sentence!!!
Re: Heat parallel control
Posté : dim. juin 15, 2008 2:46 pm
par urology
OK!
The questin is: on my pcb AHATB of HobbyCNC i have:
pin 10=timer
pin 11=heat feadback
pin 12=auto/manual heat control
pin 16= heat.
How can i set Jedicut for the pin of mY board???
Re: Heat parallel control
Posté : jeu. juin 19, 2008 5:41 pm
par Jerome
Hi,
It's the same pin configuration on MM2001 board. Jedicut will control wire heating
Re: Heat parallel control
Posté : lun. juin 23, 2008 8:31 am
par urology
Thank you!
All OK.
But i have another question.
Is there a way to set wire radiation in Jedicut?
Re: Heat parallel control
Posté : lun. juin 23, 2008 8:16 pm
par Jerome
Hi,
Yes, it's called thickness in Jedicut
Re: Heat parallel control
Posté : mer. juin 25, 2008 2:58 pm
par urology
Yes thank you!
I can performe some test before cuttin.
Another question:
How can i convert .cnc file (GMFC) for use with Jedicut?
Re: Heat parallel control
Posté : jeu. juil. 03, 2008 10:48 pm
par Jerome
Hi,
I think someone explain this on this board but I don't remember when, and I don't fin the message... I'm searching...