Dynamic heating test problem
Posté : mer. août 20, 2008 12:14 am
Bonjour,
I have a problem with the dynamic heating test function of version 2.1.9.
I'm using a mm2001 with turbo boards in winxp.
The whole set works perfectly, no problem with the constant wire heating,
but when I try to configure and test the dynamic heating,
the wire moves as expected, but it doesn't warm up; the led of the board doesn't light up too.
I can't change the values of the pins relative to the wire in the communication setup panel, maybe is it normal?
Any help will be very appreciated.
Thanks to Jerome for the fantastic work.
Stefano
Italy
I have a problem with the dynamic heating test function of version 2.1.9.
I'm using a mm2001 with turbo boards in winxp.
The whole set works perfectly, no problem with the constant wire heating,
but when I try to configure and test the dynamic heating,
the wire moves as expected, but it doesn't warm up; the led of the board doesn't light up too.
I can't change the values of the pins relative to the wire in the communication setup panel, maybe is it normal?
Any help will be very appreciated.
Thanks to Jerome for the fantastic work.
Stefano
Italy