jedicut.com

Hi there,

I am tring to set jedcut up to work with a pminmo breakout board. I need to be able to change the the engine on / off to Pin 14 and not 17. If I try and change this the numbers do not change.

Regads

Prboz

I am actually using mach3 with with this board.

regards

Hi,

This is normal. I block this functionality because if some users set a bad configuration, the parallel port burn... Can you modify your board parallel port pin ?

Hi Jerome,

Not easily, it is set to pin 14 on the pcb so that makes it a little tough. could you modify and send a file to change it to 14?

Thanks

Prboz

I can try to send to you a special Jedicut version but you can quickly test it by modifying your parallel port link.

Why not free setting Engine on/off bit and other heating bits (V2.1.9)?

Because of bad configuration of Jedicut's users A bad configuration can burn parallel port. So I decided to add many control, and I have to test it.

My Controller fix wirred, therefore need more liberty config in software.

I'm interreset in a more liberty config as well
Jerome maybe you can do a version for people like us ;-)
a pinsetup in the ini file it is fine for me; i do not need a gui


Reg

Joachim

Not in the next Jedicut version, but the one after