External Timer
Posté : mer. déc. 24, 2008 1:45 am
I'm trying to make a controler board based on a L297 / L298 setup to work with Jedicut.
I would like to know what kind of input pin 10 wants.
There is an RC network connected to the pin named OSC on the L297 that controles the chopper rate, can i use this to connect to pin 10?
OR
There is a pin named SYNC that outputs the on-chip chopper oscillator, this pin is used for synchronizing with the other L297, or may be used with an external synchronizing clock, can i use this to connect to pin 10?
And could you please give me an explenasion of the pin's 17, 16, 11 and 12? (Input or Output, waves or singe state)
Kind regards
Peter Christensen
I would like to know what kind of input pin 10 wants.
There is an RC network connected to the pin named OSC on the L297 that controles the chopper rate, can i use this to connect to pin 10?
OR
There is a pin named SYNC that outputs the on-chip chopper oscillator, this pin is used for synchronizing with the other L297, or may be used with an external synchronizing clock, can i use this to connect to pin 10?
And could you please give me an explenasion of the pin's 17, 16, 11 and 12? (Input or Output, waves or singe state)
Kind regards
Peter Christensen