:SThe machine opportunities are about 5-6 turns/s (CLK = 1500 Hz) so I hope work "Fast" about 4-5 turns/s and "Slow" 2 turns/s (1 turn = 1 mm).
X( I'm having an idea: I can take signal CLK, for example 1,5 kHz, from rectangular wave generator and DIR, ENABLE from Jedicut. What You think about?
Best regards
Re: ENABLE - Lo
22Sorry!
Ideas with generator is not wise:o. I wrote it befor I thought about.
Ideas with generator is not wise:o. I wrote it befor I thought about.
ZbigPL
Re: board type - compatibility
23Hi Jerome
My machine uses Probotix boards. Will Jedicut work?
Regards
Pieter
My machine uses Probotix boards. Will Jedicut work?
Regards
Pieter
Re: board type - compatibility
24Hello,
Without more details ? I don't know... But you can try !
Without more details ? I don't know... But you can try !
Jerome