Page 1 sur 1

Jedicut and 3D-Step card by Ostermann?

Posté : lun. nov. 30, 2009 5:35 pm
par Nik
Hi there,

I`m trying to use jedicut with my 3D-Step card - but none of the dll`s with customized parameters does work.
Where do i get a .dll for my card? I used google a lot, but it seems like, i`m the only one with such problems.

Any hints?

greets, Nik

Re: Jedicut and 3D-Step card by Ostermann?

Posté : lun. nov. 30, 2009 5:44 pm
par bozzo 12
hello nik, what-is 3d-step-card ??
where do you find-it?
hugo

Re: Jedicut and 3D-Step card by Ostermann?

Posté : lun. nov. 30, 2009 5:49 pm
par Nik
Hi,

http://www.nc-step.de/step3d-e.html

(i got it with 4 channels.)

here is some documentation:

http://www.nc-step.de/pdf/3dstep_doku_27_en.pdf

greets, Nik

Re: Jedicut and 3D-Step card by Ostermann?

Posté : dim. déc. 06, 2009 8:33 am
par Jerome
Hi,

You can try. If Jedicut don't work with your card, you can program your own dll following this tutorial :
http://www.aeropassion.net/leblog/pages ... un-plug-in

:)o

Re: Jedicut and 3D-Step card by Ostermann?

Posté : sam. déc. 19, 2009 1:59 pm
par Frank
Dear Jerome,
is the tutorial also in english available?
Best regards
Frank

Re: Jedicut and 3D-Step card by Ostermann?

Posté : sam. déc. 19, 2009 3:07 pm
par Jerome
Hi !

Are you interested in programming a new Jedicut add-ons ?

I will translate this page in the next weeks. I'm looking at Google code to publish Jedicut's dll source files, maybe under LGPL licence.

Re: Jedicut and 3D-Step card by Ostermann?

Posté : sam. déc. 19, 2009 5:02 pm
par Frank
Programming isn´t my profession. I would like to try to make a dll which support exact my board with the Alegro A3977SED stepper driver.
The specification of the signal is on the following link: http://www.datasheetcatalog.org/datashe ... s/3977.pdf on page 8. Is it possible to built the dll?
Frank