Page 1 sur 1
Bug - Skin thickness is not saved for wing cut
Posté : jeu. déc. 17, 2009 9:24 pm
par Simeon
Hi Jerome,
The skin thickness details are not saved for a wing cut. This caught me out when I cut a supposedly 'matching' replacement core that was actually quite different!
Simeon.
Re: Bug - Skin thickness is not saved for wing cut
Posté : sam. déc. 19, 2009 9:23 am
par Jerome
Hi !
What Jedicut version do you use ?
Re: Bug - Skin thickness is not saved for wing cut
Posté : lun. déc. 21, 2009 1:47 am
par Simeon
Hi Jerome,
When I posted initally, I was using 2.2.0 build 1.
Your question caused me to check for a newer version - so I have installed 2.2.1 build 7.
Unfortunately the bug still exists.
Simeon.
Re: Bug - Skin thickness is not saved for wing cut
Posté : mer. déc. 23, 2009 12:59 pm
par Jerome
I will take a look at this.
Thanks for the report
Re: Bug - Skin thickness is not saved for wing cut
Posté : lun. déc. 28, 2009 7:40 pm
par Jerome
Hi,
This feature seems to run perfectly on the new Jedicut beta version available here :
http://www.aeropassion.net/leblog/post/ ... ne-oblique
Fixed - Skin thickness is saved for wing cut
Posté : lun. janv. 04, 2010 11:55 pm
par Simeon
Hi,
Thanks for fixing this. I will check for beta releases in the future before raising bugs for your attention..
I am now also looking forward to making angled cuts instead of propping foam on blocks to make the angle!
Keep the good work coming.
Simeon.