jedicut.com

Hi,

Jedicut does not connect to my parallel port, the port address is FE98 can you modify the jedicut.dll so that it will work? My OS is winXP sp2 and I will be using stepperworld FET-4 board.

I have tested the parallel port with mach3 and it works perfectly by just pointing it to this port address.

Is it possible for you to add a port address option within the Parallel Port Confguration page in jedicut?

Thank you

Hello !

You can try this new dll : http://code.google.com/p/jedicut-extens ... s_v0.1.zip

You will be able to modify the parallel port adress in a txt file.

I have tested this and still have problems, it doesn't send any output to parallel port in manual control, and if i cut it comes with "Exception EConvertError dans le module CncNet_win_xp_vista_7_32_x64.dll dans 00006B56

Do you have any ideas?

Thanks,

Dave

I have no checked the output pin voltage whilst using the manual control and am getting the correct results, so hopefully this should work when I connect the stepperworld fet4 board.

At the moment, with no board connected, I still get the "Exception EConvertError dans le module CncNet_win_xp_vista_7_32_x64.dll dans 00006B56" message when I try to cut.

Do you know what this means? Is it a problem?

Thanks,

Dave

Hello Dave,
Please test the followings steps :

-Your parallel port is listed in your "device manager" as "communication port", is named like "LPT", and the address you have indicated is the address base (the first of the parallel port).

-Download again the last version of the plug-in.

-Be sure the plug-in setup is correct : It's an .ini file wich contain the address (the .txt version is out of date now ) and it must be in Jedicut's folder, with the file "inpout32.dll".

-When you choose the plug-in communication, the address must be correct : "Utilisation de la MM2001 avec systèmes Windows 32 et 64bits. Adresse du port paralèlle : FE98"

I have tested this plug-in with windows XP SP3 and a MM2001 (parallel interface with address CFF8), and it works.

Vince

Vince
First of all thank you for making this plug in available to us.
I have the same problem but my pci card works in manual.
The port is set correct but I get the same error in cut.

Regards
Rob

Hello Rob,

Please post the informations of your parallel port listed in your device manager (name, adress, mode...)

I remember I has this bug once or two time since the plug-in's development, but unfortunaly I forgot the issue :p...

Be careful, it must exists just ONE jedicut.exe on the computer, because the plug-in search the ini file into the jedicut's folder, in the computer's folders. If there is many jedicut.exe, may the plug-in couldn't found the correct jedicut folder, and the correct adress port.

Vincent
Thanks for your reply.
See attached Pics. I am unable to see any mode setting!

Rob

LPT3 looks to be on CC00 not FE98. Are you connecting your driver board to LPT3?

Hello,

Rob, steve's right, the adress base to use is CC00.

Where the FE98 come from ??