XP and 4 axis driver
Posté : mer. févr. 15, 2006 3:01 am
Hi all:
I was thinking about using a MM2001 board to interfase Jedicut with the 4 motors, using XP in my computer, but... after reading general info seems that the MM2001 programing PIC soft only works on Windows 98 .
Is there any other known way or board to drive the motors and the heat control reliably for a complete machine running under XP .???
Page to download PCB design and circuit to build it ?
Thanks.
Jorge
Argentina
I was thinking about using a MM2001 board to interfase Jedicut with the 4 motors, using XP in my computer, but... after reading general info seems that the MM2001 programing PIC soft only works on Windows 98 .
Is there any other known way or board to drive the motors and the heat control reliably for a complete machine running under XP .???
Page to download PCB design and circuit to build it ?
Thanks.
Jorge
Argentina