Not sure if Jedicut is right for me
Posté : jeu. mai 05, 2011 8:43 pm
Hi guys,
actually I'm working with S4Cut from StepFour.
This is a really nasty DOS-based application and I need to get rid of it.
For this I'm searching for a new Software which should work on WinXP or higher.
My Hardware is this here:
http://shop.strato.de/epages/61125483.s ... SM44PCV5.2
It's controlled over parallel port.
I'm looking for a software, where I could load dxf files, define cutting-settings and directly cut on my machine.
Could Jedicut do this job ? Or do I need any additional software ?
Perhaps there is a german manual available for jedicut or at least an english?
Many thanks
Tele
actually I'm working with S4Cut from StepFour.
This is a really nasty DOS-based application and I need to get rid of it.
For this I'm searching for a new Software which should work on WinXP or higher.
My Hardware is this here:
http://shop.strato.de/epages/61125483.s ... SM44PCV5.2
It's controlled over parallel port.
I'm looking for a software, where I could load dxf files, define cutting-settings and directly cut on my machine.
Could Jedicut do this job ? Or do I need any additional software ?
Perhaps there is a german manual available for jedicut or at least an english?
Many thanks
Tele