Page 1 sur 1

Error Win-7

Posté : mar. déc. 20, 2011 1:05 am
par MAES
Hallo,

whwn i will Start Jedicut under Win-7, i become
the Message in the Attach.

have anyone a Idee, where the Problem come?

Thank's, MAES

Re: Error Win-7

Posté : mar. déc. 20, 2011 8:15 am
par vercomax
Do you have this problem every time you launch jedicut? I have been a once and nothing since. I use w7 32

Re: Error Win-7

Posté : mar. déc. 20, 2011 11:23 am
par MAES
This Error come every time.

When i push "ok"(4 or 5 times), Jedicut run, but cannot configure.
When i take any Hardware .dll, the Error come.
I use Win-7/64 without LPT.(Notebook)
For Jedicut i will use the Xavier-USB as Hardware.

Re: Error Win-7

Posté : mar. déc. 20, 2011 11:25 am
par vercomax
Try to excecute Jedicut with W xp sp3 compatibility

Re: Error Win-7

Posté : mar. déc. 20, 2011 2:31 pm
par MAES
[quote=vercomax]
Try to excecute Jedicut with W xp sp3 compatibility[/quote]

I try it so, is the same Probleme

Re: Error Win-7

Posté : mar. déc. 20, 2011 11:39 pm
par MAES
Hallo,

i have found the Problem.
Show here: http://www.aeropassion.net/forums/read.php?19,4548

Re: Error Win-7

Posté : mer. déc. 21, 2011 7:07 am
par Jerome
Hello,
Can you resume your solution ?
Files were not in the right directory ? Or you don't delete uncompatible dll in Jedicut's directory ?

Re: Error Win-7

Posté : dim. déc. 25, 2011 10:06 am
par Vincent
Hello (and have a happy christmas :)

IO.sys doesn't work with win 7.

You should install the newest version of Jedicut which normally doesn't install the IO.sys if win 7 is used.

Re: Error Win-7

Posté : dim. déc. 25, 2011 3:31 pm
par MAES
Hello (and have a happy christmas)

I have replaced from the Jedicut-directory: io.dll
My Win7 Notebook have no LPT-Port.
I have replaced from the Jedicut-directory\dll: CncNet_XP.dll, CncNet98.dll, MaxCom.dll, MaxCom_XP.dll,
MDLCNC_XP.dll, VisualCNC.dll, VisualCNC_XP.dll.

Manfred