jedicut.com

Can you provide some instruction for making single pass wing cuts in the new version please?

Thanks,
EB

Never mind, just found the "inverse" check box.

Thanks, lovin' the software!

Hello all

Please tell me, where is these check box?
How could i do a Singel Pass Cut?

In the new Version i get some Problems with Skin Thickness in Inverse Mode. It is not working.

Gruß Ingo

Hi,

Skin thikness don't work with all profiles. I have to improve it. Since last Jedicut verison I don't change it.

When you open the "Cycle of Cut" window configuration, you can see a checkbox between all others steps options called "inverse". This check box is enabled only when you click on extrado or intrado in the steps list.

Many Thanks,

your Software is great.
Go on with that Projekt.

Bests Regards from Germany

Ingo

I assume a 'single pass cut' is when the hotwire cuts around the profile without having to do the top and bottom in seperate runs.... then how does clicking the 'inverse' box in the wing page change anything? I look at the cycle cut manager , after clicking inverse (as explained above) and their are lines in weird directions, it doesn't make sense. Help! :-)

Hi,
With the default cycle of cut, is the cur correct ?
Take a look at your profile in order to check if you don't have more null point than needed.