Cutting speed
Posté : dim. juin 24, 2012 11:32 pm
Hello everybody,
I am using jedicut with the controler board from Letmathe CNC.
I have problems with the cut speed and the fast speed. Just to get the settings right, the values in the controller setting is the time between to steps. So for small values the stepper should go fast, and for big values the motor goes slow. Is that right?
My settings can be seen in the attached file. I have for both values "1", since my steppers work in 1/8 mode and I have a very low Nb mm/pas value of 0.0005. I also use the CNCNet_XP_Vista_7.dll and have no external timer. But my cutting speed is still very slow.
Furthermore, the speed for the extrado and the intrado seems to be half the speed.
Am I getting something wrong or why I are my speeds slow and the cutting speed for the extrado even slower?
Regards,
Josef
The cnc controller setting
I am using jedicut with the controler board from Letmathe CNC.
I have problems with the cut speed and the fast speed. Just to get the settings right, the values in the controller setting is the time between to steps. So for small values the stepper should go fast, and for big values the motor goes slow. Is that right?
My settings can be seen in the attached file. I have for both values "1", since my steppers work in 1/8 mode and I have a very low Nb mm/pas value of 0.0005. I also use the CNCNet_XP_Vista_7.dll and have no external timer. But my cutting speed is still very slow.
Furthermore, the speed for the extrado and the intrado seems to be half the speed.
Am I getting something wrong or why I are my speeds slow and the cutting speed for the extrado even slower?
Regards,
Josef
The cnc controller setting