jedicut.com

Hello all. Please help me.

My MM2001 still not to work with Jedicut. With GMFC working properly but does not respond to commands from Jedicut.
Motor LED on MM2001 still not flashing if Jedicut run in cut mode, but but the indicator shows correctly during the cutting process to the end.
I have set CncNet_XP.dll plugin and running on WinXP sp3. Thank you very much. Peter

Hello,

What speed values do you set up ?

If you have problem I think that you should uninstall gmfc parallel port driver.

Thanks very much Jerome.

My problem was bad values ​​in setting for the motor and CNC controller.
Nb mm / passport I have now 0.005 and everything is perfect.
Motor LED in mm2001 not flashing as when working with GMFC, it confused me too.

I am satisfied with Jedicut.

-D