hello.
i am now managing to cut out wing cores fairly close to target chords. i have found the pause function is not working for me.
a "stop" in the cut cycle with a resume start when ready would be useful.
having trouble cutting tapperd wings
i tried using "skin" for kerf compesation. but when i check the inverse box the picture in cut preview looks messed up. although the cycle of cut looks ok the wire goes off on a different path.
at this point i am making chord length adjustments till i end up with what i was expecting. ( or is this what i should be doing anyway).
slowly getting used to the basics of it.(tu)
jeremy
Re: kerf comensation. and cycle of cut "pause"
2Hi Jeremy,
What does means "the pause function is not working for me"? With Jedicut version you used? (Beta or Stable release?)
The pause function is just a 2 second delay without confirmation or popup to cut restart. You can't really pause and resume your cut with the pause function.
I hope this explaination can help you.
A+
Xavier
What does means "the pause function is not working for me"? With Jedicut version you used? (Beta or Stable release?)
The pause function is just a 2 second delay without confirmation or popup to cut restart. You can't really pause and resume your cut with the pause function.
I hope this explaination can help you.
A+
Xavier