Hi,
I have a 3D Step controller, a friend got a GWR Controller.
Both dont got a timer on board and offer the timer signal on pin 10.
At http://gm.cnc.free.fr/CNC/timer_quartz.zip I found a small circuit, to build a small timer.
Question: if I built this timer and attach the signal on PIN 10, would this work with Jedicut?
Right now we got with the GWR device major problems. Jedicut is more or less not useable.
An thoughts, comments, ideas?
Jens ( http://www.tron-cnc.de )
Re: CNC Step + own Timer
2Hello,
Jedicut works with or without external timer. But your cnc board need to be compatible with the kind of signals Jedicut send.
Jedicut works with or without external timer. But your cnc board need to be compatible with the kind of signals Jedicut send.
Jerome