Hello,
Can any one point me in the right direction I have been using GMFC software for some time. I recently installed jedicut. i Cant seem to make the heat work. I am using the proper dll. file. for hobby cnc board. The box is checked for sync with motors. I can get power to bow in manual heat with no up of down control, but noting in auto. Can some one help me configure my heat setup?

Hi,

Do you set up material ?

I tried but i must not understand how to correctly

You need to configure the good heating value with 2 different speeds. You just have to use the heating wizard configuration, in Jedicut options.

Do you try to use it ?

Still no luck , Jedicut does not recognize heat in manual position, even though the bow heats up..

Do you take a look at the pin configuration ?

hi
I have same style problem with jedicut and external timer.
I have not managed to install the temperature setting on various materials in jedicut heat options. When i set up travel lenght for example 100mm and i press test button, then wire moves but do not heat up.
Temperature value did not change what ever i do, there read always -1% heating value.

Manual control works fine, wire heat up and axles moves


I use this driver board http://www.hobbycnc.com/products/hobbyc ... oard-kits/
and extrenal timer is http://rc-letmathe.de/product_info.php? ... ts_id=1282


please help me !

/ rboy

Hello,

i use the MM2001. The heating is good.

-1% heating value i become, when the heating-switch is off.

I think, you must show to the input-pins + configuration.

Manfred

Hello,

What dll do you use ? You have to use the plugin cncnet_xp.dll or similar.

Hello

i have tried solve my heating problems but nothing did not help !
when i set manual heating value etc 100% and press validate putton its works fine ! axes move and wire get full voltage.
50% wire gets half voltage.
Manual heating: http://s166.beta.photobucket.com/user/b ... 9.jpg.html
Full voltage: http://s166.beta.photobucket.com/user/b ... n.jpg.html

When i tried use heating control wizard, it's almost works. Axes move fast or slow as it should be.
only wire did not heating, voltage is zero
Control wizard: http://s166.beta.photobucket.com/user/b ... p.jpg.html
Voltage zero: http://s166.beta.photobucket.com/user/b ... e.jpg.html

Parallel port setup: http://s166.beta.photobucket.com/user/b ... t.jpg.html

I have tried different communication mode but it no help.

Extrenal timer is: http://rc-letmathe.de/product_info.php?products_id=1393

Stepper drivecard is: http://www.hobbycnc.com/products/hobbyc ... oard-kits/


help me please