Hi Jerome,
The skin thickness details are not saved for a wing cut. This caught me out when I cut a supposedly 'matching' replacement core that was actually quite different!
Simeon.
Re: Bug - Skin thickness is not saved for wing cut
3Hi Jerome,
When I posted initally, I was using 2.2.0 build 1.
Your question caused me to check for a newer version - so I have installed 2.2.1 build 7.
Unfortunately the bug still exists.
Simeon.
When I posted initally, I was using 2.2.0 build 1.
Your question caused me to check for a newer version - so I have installed 2.2.1 build 7.
Unfortunately the bug still exists.
Simeon.
Re: Bug - Skin thickness is not saved for wing cut
4I will take a look at this.
Thanks for the report
Thanks for the report
Jerome
Re: Bug - Skin thickness is not saved for wing cut
5Hi,
This feature seems to run perfectly on the new Jedicut beta version available here :
http://www.aeropassion.net/leblog/post/ ... ne-oblique
This feature seems to run perfectly on the new Jedicut beta version available here :
http://www.aeropassion.net/leblog/post/ ... ne-oblique
Jerome
Fixed - Skin thickness is saved for wing cut
6Hi,
Thanks for fixing this. I will check for beta releases in the future before raising bugs for your attention..
I am now also looking forward to making angled cuts instead of propping foam on blocks to make the angle!
Keep the good work coming.
Simeon.
Thanks for fixing this. I will check for beta releases in the future before raising bugs for your attention..
I am now also looking forward to making angled cuts instead of propping foam on blocks to make the angle!
Keep the good work coming.
Simeon.