Hi guys,
actually I'm working with S4Cut from StepFour.
This is a really nasty DOS-based application and I need to get rid of it.
For this I'm searching for a new Software which should work on WinXP or higher.
My Hardware is this here:

http://shop.strato.de/epages/61125483.s ... SM44PCV5.2

It's controlled over parallel port.
I'm looking for a software, where I could load dxf files, define cutting-settings and directly cut on my machine.
Could Jedicut do this job ? Or do I need any additional software ?
Perhaps there is a german manual available for jedicut or at least an english?

Many thanks
Tele

Jedicut doesn't open dxf files very well but I'm working on it. Jedicut support german language but help file is only available in english and french.

Hi Jerome,
I tried it and, as you said, dxf seems to be a problem.
Is there a better version available soon or is there any workaround how to solve the problems?

Hello,

I'm actually working on a new solution.