Hello,
I have a question.
What do the key points in the cycle of cut manager?
Re: Key Point
2Hello !
Key points are used to synchronize the wire (to synchronize the cut between two point). You must add the same number of key points on the two profiles of your cut.
Key points are used to synchronize the wire (to synchronize the cut between two point). You must add the same number of key points on the two profiles of your cut.
Jerome
Re: Key Point
3Hi
Jerome,thanks for the quick reply, now I understand!
In the German translation, I will call this "Synk.Punkt."
Greetings, Manfred
Jerome,thanks for the quick reply, now I understand!
In the German translation, I will call this "Synk.Punkt."
Greetings, Manfred