jedicut.com

No, directly connect PC USB - Xavier boar!
Old version (JediCut) good works with Xavier board (bat very slow motion available only)! Only new version not work!
I see Xavier dll (in old and new version), bat they are alike...

Hello Jerome!

New version (V2.2.2) work with Xavier USB board and speed is more, Thank You!:)-D
I found a problem: if not use Smooth option in manual move, then not change direction in value of +-Move(mm)! Only one direction rotation of step motor. If use Smooth option, all ok (bat under such less speed)!

Hello,

I'm sorry but I don't know where to search, and without CNc board it's difficult...

Do you receive my last email ?

Jerome Wrote:
-------------------------------------------------------
> Hello,
>
> I'm sorry but I don't know where to search, and
> without CNc board it's difficult...
>
> Do you receive my last email ?

Hello Jerome!

No, please send again!

It's done

I have a problem with version 2.2.2. Basically the engine is x2, which works incorrectly .. I've done several tests and it is not ...

hallo Jerome,

I construted the Xaver USB board and tried to programm the hex-Files. I connected the Board via USB to the PC. But the PC will not recognice the board.

Can you help me?

Sorry for my Englisch. I speak normally German

Juergen

Hi there. http://www.xavtronic.ch site does not work. Where can I download firmware.

Hello,

i have the file's, but to big for the attach.
i will send it to Jerome.

I would also like a copy..