jedicut.com

:SThe machine opportunities are about 5-6 turns/s (CLK = 1500 Hz) so I hope work "Fast" about 4-5 turns/s and "Slow" 2 turns/s (1 turn = 1 mm).
X( I'm having an idea: I can take signal CLK, for example 1,5 kHz, from rectangular wave generator and DIR, ENABLE from Jedicut. What You think about?

Best regards

Sorry!
Ideas with generator is not wise:o. I wrote it befor I thought about.

Hi Jerome

My machine uses Probotix boards. Will Jedicut work?

Regards
Pieter

Hello,

Without more details ? I don't know... But you can try !