jedicut.com

till not, but if i can help on this project please contact with me.

Ambass

Hello,

Can you try this new plugin ? I inverted the general enable signal.

After you try, can you indicate the configuration of parallel port in Jedicut ?

Tomorrow i'll test it! Thank's!

Nothing to do...

My setup:
http://img2.indafoto.hu/2/1/110401_d252 ... af7_xl.jpg
http://img1.indafoto.hu/2/1/110401_d252 ... b37_xl.jpg

Hello,

Do you have an external timer on your CNC board ?

If not, it's normal that you don't check the check with the label "Synchronize with external timer" (on your second screenshot in another language).

With this configuration, you can't use speed values like "4" or "10". You must use speed value like 10000000. If it's to slow, try to remove one zero, or divide this value by 2. Step by step, you must adjust your speed value.

If you never see one step done by your motor, there is another problem.

Ambass

Have you made a parallel crossover lead between the pc parallel output and the parallel input of the TB6560.
The connections are on the last post first page of this subject.
My setup has been working for over a year now with no problems.
I will list all of my jedicut settings here when I return home and check my workshop computer.

Rob

Hi Jerome!
I was tried your suggestions, but it doesn't work. nothing to do...

RoB!

Waiting four your settings!!!!

Thanks

I,ve been away for a few days. Here are my settings.

Control card TB6560 switch 5 on all other switches off.

Communication:
Active Table------Default
Mode-------VisualCNC_xp.dll

Engines Clock Dir

x1 8 9
x2 4 5
y1 6 7
y2 2 3

Ex Timer 10 Heating 16
Engine on/off 17 11
12

Syn engine rot-------off (no tick)

X1,X2,Y1,Y2 All the same: Nb mm/pas 0.0025 (this is for my 6mm treaded drives)
Cut Speed 50 (0.19mm/s)
Fast Speed 15 (0.59mm/s)

No heating control (no tick)

Hope this helps good luck. Rob

Ex Timer 10
engine on/off 17
Heating 16
Return pin 11
Status 12

Did not attach correctly

Today may will test it's! Thanks!