jedicut.com

I'm using a theremino parallel adapter (http://www.theremino.com/en/hardware/adapters#cnc). This setup uses absolute distance mode,G90 gocde.

Has anyone found a utility to convert G-code incremental / relative coordinates to absolute?

Or an updated JediCut plugin that support absolute distance?

Hello

I don't know if such utility exist.

For the moment Jedicut only generate relative mode. I may work on absolute mode during 2018 if there are interesting people, and brave testers with Theremino adaptor.

Before that I want to work on heating control. I must correct it and improve it.

What software do you currently use ?

Thanks Jerome.

I'm currently using DevWing Foam. Started with JediCut and have a collection of wings setup for JediCut that I have yet to move to the New Software.

For heat control I'm using a Microprocessor controlled, [b]Constant Current Power[/b] supply with good success. What are you planning on for heat control?

Hello

Why do you change software ?

I want to improve heating control