First project with the foam cutter.
Posté : ven. mars 02, 2018 10:37 pm
Hello everyone
First project with Schaum Schneider and Jedicut 2.4
A little video https://youtu.be/8lEdGlvFL6o
The result is very good and with Jedicut also easy to handle.
Sweep of the wing are 24.2 degrees.
Thanks to Alain for the great Alden Ramps 1.4.
I still have a suggestion.
When cutting arrow wings, the axis that goes the long way goes back to the beginning. It would be better for me if the entire portal would only drive to the beginning of the block.
Good night to all
Rudi
First project with Schaum Schneider and Jedicut 2.4
A little video https://youtu.be/8lEdGlvFL6o
The result is very good and with Jedicut also easy to handle.
Sweep of the wing are 24.2 degrees.
Thanks to Alain for the great Alden Ramps 1.4.
I still have a suggestion.
When cutting arrow wings, the axis that goes the long way goes back to the beginning. It would be better for me if the entire portal would only drive to the beginning of the block.
Good night to all
Rudi