Help !!!
Posté : lun. mars 05, 2018 2:15 pm
<r>Hello<br/>
<br/>
need your help.<br/>
<br/>
How should I cut this wing with Jedicut.<br/>
I split the wing on 3 segments. Sweep is 24.4 degrees.<br/>
The segment 1 is ready the 2 segment is feasible on my machine.<br/>
My processing. Machine with X-axis at angle 24.4 degrees driving. cut the profile as a straight profile.<br/>
For segment 2, the same process.<br/>
Segment 3<br/>
My machine can not drive this angle, how should I cut this part.<br/>
<br/>
Thank you
<ATTACHMENT filename="zeze001.JPG" index="0"><s> </e></ATTACHMENT>
'KIND REGARDS<br/>
<br/>
Rudi</r>
<br/>
need your help.<br/>
<br/>
How should I cut this wing with Jedicut.<br/>
I split the wing on 3 segments. Sweep is 24.4 degrees.<br/>
The segment 1 is ready the 2 segment is feasible on my machine.<br/>
My processing. Machine with X-axis at angle 24.4 degrees driving. cut the profile as a straight profile.<br/>
For segment 2, the same process.<br/>
Segment 3<br/>
My machine can not drive this angle, how should I cut this part.<br/>
<br/>
Thank you
<ATTACHMENT filename="zeze001.JPG" index="0"><s> </e></ATTACHMENT>
'KIND REGARDS<br/>
<br/>
Rudi</r>