Jedicut with Hobbycmc board timer problems
Posté : sam. janv. 06, 2007 10:16 pm
I'm Trying to set up Jedicut with the HobbyCNC board with timer and autoheat, using the CNCnet driver. Windows XP version of driver.
It should work with the timer control, but only works with the timer control turned off (unchecked).
The timer is working with Fcut so I know it isn't the board. I uninstalled Fcut and it's driver to be sure it was not interfering, and that didn't help.
What am I missing??????
Is there a way to see in Jedicut if the timer is getting to the program??
It should work with the timer control, but only works with the timer control turned off (unchecked).
The timer is working with Fcut so I know it isn't the board. I uninstalled Fcut and it's driver to be sure it was not interfering, and that didn't help.
What am I missing??????
Is there a way to see in Jedicut if the timer is getting to the program??