jedicut.com

Hello!

I have been trying around with jedicut for while, and so far it is working great, but I simply could not find out whether there is a possibility to set up the kerf correction (that is, the amount of foam the wire eats up at different speeds).

Is there a possiblity to do that? As far as I understand this is necessary to cut accurate forms without having to take care of that at drawing time, which would be very cumbersome.

Thanks in advance,
Balazs

Hi,

Yes you can do it ! For each cut, you have to fill "skin" field on the wing cut form. You can set differents value for root and tip profiles.