jedicut.com

I am running windows XP.

I have tried them all and they all have the 'wrong' enable signal... (Only vista and windows 7 dll gets error popup ... in french...;(

Willing to try anything you have....

Thanks !!!!

-Doron.

Do you try CnCnet_xp.dll and after that visualCNC_xp.dll ?

Can you explain what is "the wrong enable signal" ? Are you talking about the clock of each motors or the general "enable" signals for the board ?

I tried all the dll's and none works.

The only DLL that seems to 'almost' work is the CncNet_win_XP_Vista bit it gets an error popup... see attached file.

When I tell it to do a long movement with the CncNet_win_XP_Vista, ignore the popup error and then use the parallel port monitor and toggle pin 1 (general enable signal)... the motor move.

In any case, the general 'enable' signal is always the opposite of what this board needs.

See controller doc here : http://wenku.baidu.com/view/f6342ad0496 ... 747b4.html

So can I try next. do you have these DLL's with ability to change the polarity

-Doron.

Hello,

You can try this dll. I inverted the general enable signal as you like. I will answer your other messages tomorrow.

the signal is has not changed ...

Also you can see with this utility http://www.geekhideout.com/parmon.shtml

I now know that pin one (1) needs to be high (and not low as I thought).

I defined Engine on/off as pin 1 in the GUI but according to Parmon software nothing change.... (When Mach3 runs... that pin is green)

I am not sure you are sending the data to that pin.


-Doron

Tell me exactly what you want because I have difficulties to understand.

pin 1 for general Enable signals.
High level signal to enable your board.
Low level signal (0) to unable your board.

Is it right ?

Yesterday I did a quick modification on cncnet_xp.dll to invert high and low level on this signal. Are you sure that you use the dll I posted before and that you choose it in Jedicut's settings ?

Jerome,

1) Yes I am sure I put the the new DLL in that directory and slected it. (I renamed the old one to cncnet_xp_old.dll and it showed in the gui menu as cncnet_xp_old.dll)
2) Did you try the Parmon utility on your computer ? On my machine it does not look like you are stetting the motor enable pin to high on ANY of the dll's (I told it it is pin 1 on the DB-25)
3) You can see here : http://wenku.baidu.com/view/f6342ad0496 ... 747b4.html the mach3 settings that my board is using and when I use mach3 is moves just fine.

Thanks !!!!

-Doron

Same problem... It's work with mach3 fine but with Jedi won't start...

I have this one: http://www.ebay.com/itm/4-axis-TB6560-s ... 093wt_1163

Jerome!

Please develop some kind of solution! please+please+please!!!!!!!!!!!!!!!!!!! -D

Hello,

I'm sorry but don't know what to do and I don't have this board. May be you can contribute together and offer me this board ? Without the board, It's to difficult to work, and It needs too time.

Do you try rob's settings ?