New driver for board FDC4
Posté : jeu. nov. 18, 2010 10:12 pm
Hello Jerome, I'm finishing my controller prototype and I would like build my own driver for Jedicut.
I'm programmer in several languajes (C++, Java, Phyton...) and Delphi not appear complicated but I'm wondering if you could help me a bit starting the IDE and Project.
I just checkout the source of drivers projects and install Delphi7, but I'm little lost about the project configuration... I'm trying to compile CncNet_XP but it just appear nothing.
Some one suggestion to set the IDE and start project?
Thanks in advanced.
PD. you can see the prototype here: http://tallerdedalo.es/web/FDC4
I'm programmer in several languajes (C++, Java, Phyton...) and Delphi not appear complicated but I'm wondering if you could help me a bit starting the IDE and Project.
I just checkout the source of drivers projects and install Delphi7, but I'm little lost about the project configuration... I'm trying to compile CncNet_XP but it just appear nothing.
Some one suggestion to set the IDE and start project?
Thanks in advanced.
PD. you can see the prototype here: http://tallerdedalo.es/web/FDC4