Hello all! I´m Alfredo from Brasil. I just finished a arduino uno board with a CNC shield v3. I´ve followed all instructions given by TJMarch on post 207. The motors were tested and all four are working outside jedicut. I did the jedicut configuration using the same parameters as TJmarch on the same post. When I start Jedicut look´s like it is not comunicanting with arduino. I could not find a place to tell Jedicut what port my arduino is using. I do not çnow if is necessary to change the lpt port# to a usb port#.
Best regards to all
Hello, I'm from Brazil (MG). Are you using cnc Shield v3 + a4988? you have to contact you via email (email etc). Thank you.
C:\Program Files (x86)\Jedicut\
25 ini adresse_port_LPT.ini
301 ini comport.ini
46592 dll ddddio.dll
128 txt GCode_by_Jedicut_277785497.txt
128 txt GCode_by_Jedicut_278565931.txt
98304 dll inpout32.dll
6121984 exe Jedicut.exe
809 ini Jedicut.ini
2357 ini Jedicut_Default.ini
2379 ini Jedicut_df_600.ini
2379 ini Jedicut_GR_600.ini
346624 dll Jedipix.dll
sorry my english is not really good.
I´m trying to build a cnc cutter. The hardware is pretty much done but I´m having problems with the software. I have the Arduino Uno with the cnc shield V3.
I don´t have any experience with arduino yet.
I have a problem with the connection between jedicut and the arduino controller.
What did I wrong?
I copied the long code from poste #199 and uploaded it with the Arduino software on the Arduino controller.
I changed my Jedicut pinout like in code #199 discriped.
After that I created a comport.ini (there was none before) file with the code from poste #215.
My Arduino COM port is 4.