jedicut.com

Good morning
I'm trying jedicut
My configurations are attached to the message
The CNC works, there is only a problem, I can't use heating control.
When I enable the "synchronize engine rotation with external timer" the CNC stops to go.
Could you give me some advice?
Thanks

Without external-timer you can not use the heating-control in Jedicut.

You must show, that the timer-impuls from the MM2001 is correct.

[quote=MAES]
Without external-timer you can not use the heating-control in Jedicut.

You must show, that the timer-impuls from the MM2001 is correct.[/quote]

I don't have an oscilloscope but the timer-impuls is correct because i used GMFC

When the timer-impuls is correct and you have in Jedicut select "with external timer",
you must change the cut-speed to a short value (20...).

Manfred

[quote=MAES]
When the timer-impuls is correct and you have in Jedicut select "with external timer",
you must change the cut-speed to a short value (20...).

Manfred[/quote]


if I had a speed value of 80'000'000
with a timer of 2000HZ
what is the new speed value?

Thanks

you can test it with short value 20 or 50 and so on.

Manfred

[quote=MAES]
you can test it with short value 20 or 50 and so on.

Manfred[/quote]

Thank you very much
Now it works well

I attach the setting
I hope that it can be useful to others

Thanks Manfred -D