Re: Pb de définition des tronçons
Posté : dim. févr. 26, 2012 7:36 pm
[quote=MAES]I think, that in your airfoil the contours are not completely closed.
If a contour is open, closes Jedicut the contour.[/quote]
I use an old version of Profili to generate the airfoils, and I export it in dxf to AutoCAD to add the specific cutting for the fIlaps. As I drawn this cutting with the " intersection " tool, there is normally no disconnection on this area.
I cannot check the whole airfoil, there some hundreds of sections, it is impossible. At least I know that there is no disconnection at thre trailing edge as Profili automatically close the airfoil at this area.
I tried also to use AutoCAD R12 and 2004 dxf format, which are quite different, but there is no change on the Jedicut result.
I have exactly the same problem with the second section of the wing, with is planned a basic NACA 23016 / NACA 23012, without any additionnal cutting : the extrados defined by Jedicut is the intrados, and the intrados defined by Jedicut is the whole airfoil section, whatever the position of the both points 1 and 2.
Jérôme : voici mes fichiers pour l'aile :
- Emplanture : - Saumon : - Fichier jdc : J'ai fait le test avec les profils des volets. Pour l'emplanture tout est bon mais pour l'extrémité, l'intrados et l'extrados sont inversés. Voilà les fichiers :
- Emplanture : - Extrémité : - Fichier jdc : Les pofils ont été dessinés toujours avec AutoCAD avec une polyligne pour le BA arrondi et avec des droites pour le reste puis exportés en dxf directement par AutoCAD.
J'espère que ça t'aidera.
Merci d'avance et bonne soirée.
Manu
If a contour is open, closes Jedicut the contour.[/quote]
I use an old version of Profili to generate the airfoils, and I export it in dxf to AutoCAD to add the specific cutting for the fIlaps. As I drawn this cutting with the " intersection " tool, there is normally no disconnection on this area.
I cannot check the whole airfoil, there some hundreds of sections, it is impossible. At least I know that there is no disconnection at thre trailing edge as Profili automatically close the airfoil at this area.
I tried also to use AutoCAD R12 and 2004 dxf format, which are quite different, but there is no change on the Jedicut result.
I have exactly the same problem with the second section of the wing, with is planned a basic NACA 23016 / NACA 23012, without any additionnal cutting : the extrados defined by Jedicut is the intrados, and the intrados defined by Jedicut is the whole airfoil section, whatever the position of the both points 1 and 2.
Jérôme : voici mes fichiers pour l'aile :
- Emplanture : - Saumon : - Fichier jdc : J'ai fait le test avec les profils des volets. Pour l'emplanture tout est bon mais pour l'extrémité, l'intrados et l'extrados sont inversés. Voilà les fichiers :
- Emplanture : - Extrémité : - Fichier jdc : Les pofils ont été dessinés toujours avec AutoCAD avec une polyligne pour le BA arrondi et avec des droites pour le reste puis exportés en dxf directement par AutoCAD.
J'espère que ça t'aidera.
Merci d'avance et bonne soirée.
Manu