[quote=MAES]
When you move manual the axis x or y with a value 250mm ,
the axis must drive 250mm.

You can test it and maesure the distance.
Is the distance not correct, you must change in Jedicut the value for "nb mm/pas".

You can make a simple projekt with one rectangle as airfoil and symetric ...

Good morning

I have a problem
With my CNC I cut the figure in Annex A.
I imported the profile in jedicut (see Annex B)
On jedicut I see the right profile (see attachments C)

When cutting the foam, the geometry does not match with the program. (See clouds on Annex A)
I state that the axes of ...

[quote=MAES]
you can test it with short value 20 or 50 and so on.

Manfred[/quote]

Thank you very much
Now it works well

I attach the setting
I hope that it can be useful to others

[quote=MAES]
When the timer-impuls is correct and you have in Jedicut select "with external timer",
you must change the cut-speed to a short value (20...).

Manfred[/quote]


if I had a speed value of 80'000'000
with a timer of 2000HZ
what is the new speed value?

Thanks

[quote=MAES]
Without external-timer you can not use the heating-control in Jedicut.

You must show, that the timer-impuls from the MM2001 is correct.[/quote]

I don't have an oscilloscope but the timer-impuls is correct because i used GMFC

Good morning
I'm trying jedicut
My configurations are attached to the message
The CNC works, there is only a problem, I can't use heating control.
When I enable the "synchronize engine rotation with external timer" the CNC stops to go.
Could you give me some advice?
Thanks