Number mm / step : Indicate distance between 2 steps. dose not seem to add up, I have it set at .6 to get 40mm/rev. This is just a estimate until I have machine setup. I bought; http://www.ebay.com/itm/V3-Engraver-Shield-3D-Printer-CNC-Expansion-Board-A4988-Driver-Board-for-Arduino-/272382819802?epi...

Hello Jerome
Was able to get motor to move in all driver positions on board. Just need to fine tune. Thank you

Tim

Thank you Jorme I think I understand you question now had to do some rereading. I am using cut speed of 25 and fast speed of 15. I read in earlier post, [You may also experiment with "Cut speed" and "Fast Speed" in the CNC Controller settings. I use 127 and 20/quote]. I will try ...

Jorme was trying to give as much info as possible forgot to answer your question. It dose not matter if I try to move axis manually 100mm and 1000mm fast or slow motor just humm Tim PS I have only one motor hooked up to engine X1 I do not want to acccidently damage more than one driver or motor whil...

Thank you for the quick reply Jerome Please try this link for shield info http://blog.protoneer.co.nz/arduino-cnc-shield-v3-00-assembly-guide/ I cannot get the stepper motor to rotate, they just hum when trying to move axis in manuel with JediCut. I have the shield set for no micro stepping using DR...

Hello to whom ever can help me. Trying to get Jedicut to work with a Arduino CNC Shield version 3. I have been working on this for a couple days and I am so close to getting this to work but now stuck and do not know what to do. I cannot get the stepper motor to rotate, they just hum when trying to...