I'm very new to Jedicut.

I've built my HobbyCNC board and run some of the Jedicut files on it
with the steppers all just sitting on my bench.
I put tape on the shafts to watch them rotate easier.

What I currently have in addition to Rhino is Profili Pro 2.8 or whatever.
AND possibly I should be ...

What I would LOVE TO SEE in an upcoming version is ...

A direct import of Stephano Duranti's Profili output !
Yes I can bring over .dat files for tip and root.
But there is the G-code output that does everything.

His 3D Sim of cutting action is terrific.
His program is low cost.

Jedicut is ...

Never mind !

I quite attempting to get better results in the Manual mode
and simply Tried one of the samples.

To my surprise AL the motors started running.

They all exhibited variable speed and directional control.

So until I finish my hardware I have no more questions ! :-)

Thanks for quick reply !

I have NO external timer.

What frequency should it be IF I make one ?
Could it be a simple 555 timer circuit ?

YES , that MaxCom.dll does work to a slight degree.

I just cannot get the Speeds to change no matter the setting.

I am using .009 mm / step

My board is ...

I am using an old win98 Laptop by Toshiba.
It uses LPT2 not LPT1 and that is on 378

I am amazed that Jedicut figured that out
I have found NOT setting to actually select that address.

I have built and tested my HobbyCNC board on all 4 axies.
I used a Parallel port monitor program to single step ...